Guys, We have a non-defined Ethernet interface showing as DOWN on both cluster members when a "cphaprob -a if" command is issued. This currently has no impact as both members are showing as healthy (Active/Standby).
The SmartDashboard effectively does NOT show eth0 as it'suppose to and a security policy push & reboot did not solve it. I was just wondering if there's a way to make this disappear without having to resort to the documented "discntd.if" file procedure. Configuration: SPLAT R71.20 Cluster ClusterXL - HA Mode Open Server [exp...@passive-fw]# ifconfig eth0 eth0 Link encap:Ethernet HWaddr F0:4D:A2:06:56:AB UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) Interrupt:146 Memory:d4000000-d4012100 Output: [exp...@passive-fw]# cphaprob -a if Required interfaces: 5 Required secured interfaces: 1 eth0 DOWN (4283.2 secs) non sync(non secured), broadcast eth1 UP non sync(non secured), multicast eth2 UP non sync(non secured), multicast eth3 UP non sync(non secured), multicast eth4 UP sync(secured), multicast eth5 UP non sync(non secured), multicast Virtual cluster interfaces: 4 eth1 X eth2 X eth3 X eth5 X Thanks ================================================= To set vacation, Out-Of-Office, or away messages, send an email to lists...@amadeus.us.checkpoint.com in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email fw-1-ow...@ts.checkpoint.com =================================================