Hi Leaf Users,
Does anybody have experience of using the PC Engines APU2 boards with BuC 5.2.x
?
I have a brand new apu2c4 board with the 20160307 BIOS.
I know the board is good because it works OK with PC Engines’ TinyCore Linux.
I've tried using the Bering-uClibc_5.2.6_i686_syslinux_serial115200.tar.gz image
extracted onto an SD card with a 2GB FAT32 partition, mounted in the on-board
SD slot.
It boots into SYSLINUX (v6.03) OK and I see the LP shield logo via the serial
console
but it hangs after:
Loading /syslinux/linux… ok
Loading /initrd.lrp… ok
Loading /initmod.lrp… ok
That implies it’s loading the files OK but it’s not able to boot the kernel,
right?
I’ve tried a few other BuC versions (5.1.7, 5.2.7-rc1) and also the x86_64
variant but with the same result.
I’ve also tried using the SD card in a USB adaptor (so the APU sees it as USB)
but again the same result.
On the Hardware Specific Guides page for the APU board I see evidence the APU
is working but maybe
the APU2 needs different drivers or something?
Thanks,
dMb
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity
planning reports. http://sdm.link/zohodev2dev
------------------------------------------------------------------------
leaf-user mailing list: [email protected]
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/
