Adam, Mark Post and Jochen - thank you for your replies.
For my unsuccesful attempts I used a ".ins" file created by myself and I
didn't know that the filenames might not be too long.
When I used the original ".ins" file from the Debian CD and changed the
filenames according to it, the installation went smoothly until the
first IPL. After the IPL I get a message from modprobe:
"can't locate module eth0". I am using OSA-2.
Is it so because I didn't load the oco.bin file ? I tried to find it on
the net but it was nowhere to be found.My distribution doesn't have it
either...
I installed the base system over the network (through FTP) without any
problems. My parmfile doesn't contain any network parameters since I
wanted to enter them manually.Why did it work for the base installation
and why did it not work after the IPL ?
Can anyone help, please?
Maciek
--
Maciej Ksiezycki
Unizeto, Poland
www.unizeto.pl
- - -
"Better ask questions before you shoot."
Bruce Springsteen
- - -
(please remove NOSPAM to reply to me directly)
