> On 4/10/19 12:47 PM, Flavio Suligoi wrote:
> > Add an info message for the PXA2xx device driver start-up,
> > with the indication of:
> >
> > - mode (slave device or master controller)
> > - transfer mode (DMA or GPIO)
> >
> > Signed-off-by: Flavio Suligoi <f.suli...@asem.it>
> > ---
> >
> > v1: - first version
> > v2: - remove warning message "no DMA channels available, using PIO"
> > - add "slave device"/"master controller" indication message
> >
> > drivers/spi/spi-pxa2xx.c | 5 ++++-
> > 1 file changed, 4 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c
> > index f7068cc..b9e04e2 100644
> > --- a/drivers/spi/spi-pxa2xx.c
> > +++ b/drivers/spi/spi-pxa2xx.c
> > @@ -1696,7 +1696,6 @@ static int pxa2xx_spi_probe(struct platform_device
> *pdev)
> > if (platform_info->enable_dma) {
> > status = pxa2xx_spi_dma_setup(drv_data);
> > if (status) {
> > - dev_warn(dev, "no DMA channels available, using PIO\n");
> > platform_info->enable_dma = false;
> > } else {
> > controller->can_dma = pxa2xx_spi_can_dma;
> > @@ -1818,6 +1817,10 @@ static int pxa2xx_spi_probe(struct
> platform_device *pdev)
> > pm_runtime_set_active(&pdev->dev);
> > pm_runtime_enable(&pdev->dev);
> >
> > + dev_info(dev, "PXA2xx SPI %s (%s mode)\n",
> > + platform_info->is_slave ? "slave device" : "master
> controller",
> > + platform_info->enable_dma ? "DMA" : "PIO");
> > +
>
> "slave device" is ambiguous. Please use "controller" with both, i.e.
> "PXA2xx SPI %s controller (%s mode)\n", ... ? "slave" : "master", ...
>
> With that changed you may add:
>
> Reviewed-by: Jarkko Nikula <jarkko.nik...@linux.intel.com>
Ok
Flavio
