Support ECM mode based on cdc_ether with relative mii
functions, when CONFIG_USB_RTL8152 is not set, or the
device is not supported by r8152 driver.
Both r8152 and r8153_ecm would check the return value of
rtl8152_get_version() in porbe(). If rtl8152_get_version()
return none zero value, the r8152 is used for the device
with vendor mode. Otherwise, the r8153_ecm is used for the
device with ECM mode.
Signed-off-by: Hayes Wang <hayesw...@realtek.com>
---
drivers/net/usb/Makefile | 2 +-
drivers/net/usb/r8152.c | 22 +----
drivers/net/usb/r8153_ecm.c | 162 ++++++++++++++++++++++++++++++++++++
include/linux/usb/r8152.h | 30 +++++++
4 files changed, 197 insertions(+), 19 deletions(-)
create mode 100644 drivers/net/usb/r8153_ecm.c
create mode 100644 include/linux/usb/r8152.h
diff --git a/drivers/net/usb/Makefile b/drivers/net/usb/Makefile
index 99fd12be2111..99381e6bea78 100644
--- a/drivers/net/usb/Makefile
+++ b/drivers/net/usb/Makefile
@@ -13,7 +13,7 @@ obj-$(CONFIG_USB_LAN78XX) += lan78xx.o
obj-$(CONFIG_USB_NET_AX8817X) += asix.o
asix-y := asix_devices.o asix_common.o ax88172a.o
obj-$(CONFIG_USB_NET_AX88179_178A) += ax88179_178a.o
-obj-$(CONFIG_USB_NET_CDCETHER) += cdc_ether.o
+obj-$(CONFIG_USB_NET_CDCETHER) += cdc_ether.o r8153_ecm.o
obj-$(CONFIG_USB_NET_CDC_EEM) += cdc_eem.o
obj-$(CONFIG_USB_NET_DM9601) += dm9601.o
obj-$(CONFIG_USB_NET_SR9700) += sr9700.o
diff --git a/drivers/net/usb/r8152.c b/drivers/net/usb/r8152.c
index d8ae89aa470c..41b803729996 100644
--- a/drivers/net/usb/r8152.c
+++ b/drivers/net/usb/r8152.c
@@ -26,7 +26,7 @@
#include <linux/acpi.h>
#include <linux/firmware.h>
#include <crypto/hash.h>
-#include <linux/usb/usb_vendor_id.h>
+#include <linux/usb/r8152.h>
/* Information for net-next */
#define NETNEXT_VERSION "11"
@@ -654,18 +654,6 @@ enum rtl_register_content {
#define INTR_LINK 0x0004
-#define RTL8152_REQT_READ 0xc0
-#define RTL8152_REQT_WRITE 0x40
-#define RTL8152_REQ_GET_REGS 0x05
-#define RTL8152_REQ_SET_REGS 0x05
-
-#define BYTE_EN_DWORD 0xff
-#define BYTE_EN_WORD 0x33
-#define BYTE_EN_BYTE 0x11
-#define BYTE_EN_SIX_BYTES 0x3f
-#define BYTE_EN_START_MASK 0x0f
-#define BYTE_EN_END_MASK 0xf0
-
#define RTL8153_MAX_PACKET 9216 /* 9K */
#define RTL8153_MAX_MTU (RTL8153_MAX_PACKET - VLAN_ETH_HLEN - \
ETH_FCS_LEN)
@@ -693,9 +681,6 @@ enum rtl8152_flags {
#define DEVICE_ID_THINKPAD_THUNDERBOLT3_DOCK_GEN2 0x3082
#define DEVICE_ID_THINKPAD_USB_C_DOCK_GEN2 0xa387
-#define MCU_TYPE_PLA 0x0100
-#define MCU_TYPE_USB 0x0000
-
struct tally_counter {
__le64 tx_packets;
__le64 rx_packets;
@@ -6607,7 +6592,7 @@ static int rtl_fw_init(struct r8152 *tp)
return 0;
}
-static u8 rtl_get_version(struct usb_interface *intf)
+u8 rtl8152_get_version(struct usb_interface *intf)
{
struct usb_device *udev = interface_to_usbdev(intf);
u32 ocp_data = 0;
@@ -6665,12 +6650,13 @@ static u8 rtl_get_version(struct usb_interface *intf)
return version;
}
+EXPORT_SYMBOL_GPL(rtl8152_get_version);
static int rtl8152_probe(struct usb_interface *intf,
const struct usb_device_id *id)
{
struct usb_device *udev = interface_to_usbdev(intf);
- u8 version = rtl_get_version(intf);
+ u8 version = rtl8152_get_version(intf);
struct r8152 *tp;
struct net_device *netdev;
int ret;
diff --git a/drivers/net/usb/r8153_ecm.c b/drivers/net/usb/r8153_ecm.c
new file mode 100644
index 000000000000..13eba7a72633
--- /dev/null
+++ b/drivers/net/usb/r8153_ecm.c
@@ -0,0 +1,162 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+#include <linux/module.h>
+#include <linux/netdevice.h>
+#include <linux/mii.h>
+#include <linux/usb.h>
+#include <linux/usb/cdc.h>
+#include <linux/usb/usbnet.h>
+#include <linux/usb/r8152.h>
+
+#define OCP_BASE 0xe86c
+
+static int pla_read_word(struct usbnet *dev, u16 index)
+{
+ u16 byen = BYTE_EN_WORD;
+ u8 shift = index & 2;
+ __le32 tmp;
+ int ret;
+
+ if (shift)
+ byen <<= shift;
+
+ index &= ~3;
+
+ ret = usbnet_read_cmd(dev, RTL8152_REQ_GET_REGS, RTL8152_REQT_READ,
index,
+ MCU_TYPE_PLA | byen, &tmp, sizeof(tmp));
+ if (ret < 0)
+ goto out;
+
+ ret = __le32_to_cpu(tmp);
+ ret >>= (shift * 8);
+ ret &= 0xffff;
+
+out:
+ return ret;
+}
+
+static int pla_write_word(struct usbnet *dev, u16 index, u32 data)
+{
+ u32 mask = 0xffff;
+ u16 byen = BYTE_EN_WORD;
+ u8 shift = index & 2;
+ __le32 tmp;
+ int ret;
+
+ data &= mask;
+
+ if (shift) {
+ byen <<= shift;
+ mask <<= (shift * 8);
+ data <<= (shift * 8);
+ }
+
+ index &= ~3;
+
+ ret = usbnet_read_cmd(dev, RTL8152_REQ_GET_REGS, RTL8152_REQT_READ,
index,
+ MCU_TYPE_PLA | byen, &tmp, sizeof(tmp));
+
+ if (ret < 0)
+ goto out;
+
+ data |= __le32_to_cpu(tmp) & ~mask;
+ tmp = __cpu_to_le32(data);
+
+ ret = usbnet_write_cmd(dev, RTL8152_REQ_SET_REGS, RTL8152_REQT_WRITE,
index,
+ MCU_TYPE_PLA | byen, &tmp, sizeof(tmp));
+
+out:
+ return ret;
+}
+
+static int r8153_ecm_mdio_read(struct net_device *netdev, int phy_id, int reg)
+{
+ struct usbnet *dev = netdev_priv(netdev);
+ int ret;
+
+ ret = pla_write_word(dev, OCP_BASE, 0xa000);
+ if (ret < 0)
+ goto out;
+
+ ret = pla_read_word(dev, 0xb400 + reg * 2);
+
+out:
+ return ret;
+}
+
+static void r8153_ecm_mdio_write(struct net_device *netdev, int phy_id, int
reg, int val)
+{
+ struct usbnet *dev = netdev_priv(netdev);
+ int ret;
+
+ ret = pla_write_word(dev, OCP_BASE, 0xa000);
+ if (ret < 0)
+ return;
+
+ ret = pla_write_word(dev, 0xb400 + reg * 2, val);
+}
+
+static int r8153_bind(struct usbnet *dev, struct usb_interface *intf)
+{
+ int status;
+
+ status = usbnet_cdc_bind(dev, intf);
+ if (status < 0)
+ return status;
+
+ dev->mii.dev = dev->net;
+ dev->mii.mdio_read = r8153_ecm_mdio_read;
+ dev->mii.mdio_write = r8153_ecm_mdio_write;
+ dev->mii.reg_num_mask = 0x1f;
+ dev->mii.supports_gmii = 1;
+
+ return status;
+}
+
+static const struct driver_info r8153_info = {
+ .description = "RTL8153 ECM Device",
+ .flags = FLAG_ETHER,
+ .bind = r8153_bind,
+ .unbind = usbnet_cdc_unbind,
+ .status = usbnet_cdc_status,
+ .manage_power = usbnet_manage_power,
+};
+
+static const struct usb_device_id products[] = {
+{
+ USB_DEVICE_AND_INTERFACE_INFO(USB_VENDOR_ID_REALTEK, 0x8153,
USB_CLASS_COMM,
+ USB_CDC_SUBCLASS_ETHERNET,
USB_CDC_PROTO_NONE),
+ .driver_info = (unsigned long)&r8153_info,
+},
+
+ { }, /* END */
+};
+MODULE_DEVICE_TABLE(usb, products);
+
+static int rtl8153_ecm_probe(struct usb_interface *intf,
+ const struct usb_device_id *id)
+{
+#if IS_REACHABLE(CONFIG_USB_RTL8152)
+ if (rtl8152_get_version(intf))
+ return -ENODEV;
+#endif
+
+ return usbnet_probe(intf, id);
+}
+
+static struct usb_driver r8153_ecm_driver = {
+ .name = "r8153_ecm",
+ .id_table = products,
+ .probe = rtl8153_ecm_probe,
+ .disconnect = usbnet_disconnect,
+ .suspend = usbnet_suspend,
+ .resume = usbnet_resume,
+ .reset_resume = usbnet_resume,
+ .supports_autosuspend = 1,
+ .disable_hub_initiated_lpm = 1,
+};
+
+module_usb_driver(r8153_ecm_driver);
+
+MODULE_AUTHOR("Hayes Wang");
+MODULE_DESCRIPTION("Realtek USB ECM device");
+MODULE_LICENSE("GPL");
diff --git a/include/linux/usb/r8152.h b/include/linux/usb/r8152.h
new file mode 100644
index 000000000000..663e694c9513
--- /dev/null
+++ b/include/linux/usb/r8152.h
@@ -0,0 +1,30 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+/*
+ * Copyright (c) 2020 Realtek Semiconductor Corp. All rights reserved.
+ */
+
+#ifndef __LINUX_R8152_H
+#define __LINUX_R8152_H
+
+#include <linux/usb/usb_vendor_id.h>
+
+#define RTL8152_REQT_READ 0xc0
+#define RTL8152_REQT_WRITE 0x40
+#define RTL8152_REQ_GET_REGS 0x05
+#define RTL8152_REQ_SET_REGS 0x05
+
+#define BYTE_EN_DWORD 0xff
+#define BYTE_EN_WORD 0x33
+#define BYTE_EN_BYTE 0x11
+#define BYTE_EN_SIX_BYTES 0x3f
+#define BYTE_EN_START_MASK 0x0f
+#define BYTE_EN_END_MASK 0xf0
+
+#define MCU_TYPE_PLA 0x0100
+#define MCU_TYPE_USB 0x0000
+
+#if IS_REACHABLE(CONFIG_USB_RTL8152)
+extern u8 rtl8152_get_version(struct usb_interface *intf);
+#endif
+
+#endif /* __LINUX_R8152_H */
--
2.26.2
