Add spi0 cs3 switch pinctrl pin definitions: this pin is used to select
between mmc0 slot0 and spi dataflash connected to cs3.
Enable spi0 controller and define the mtd_dataflash connected to cs0.
Signed-off-by: Boris BREZILLON <b.brezil...@overkiz.com>
---
arch/arm/boot/dts/at91rm9200ek.dts | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/arch/arm/boot/dts/at91rm9200ek.dts
b/arch/arm/boot/dts/at91rm9200ek.dts
index 2bad423..b3e7425 100644
--- a/arch/arm/boot/dts/at91rm9200ek.dts
+++ b/arch/arm/boot/dts/at91rm9200ek.dts
@@ -56,6 +56,13 @@
<AT91_PIOB 22
AT91_PERIPH_GPIO (AT91_PINCTRL_OUTPUT | AT91_PINCTRL_OUTPUT_VAL(1))>;
};
};
+
+ spi0 {
+ pinctrl_spi0_cs3_switch:
spi0_cs3_switch-0 {
+ atmel,pins =
+ <AT91_PIOB 22
AT91_PERIPH_GPIO (AT91_PINCTRL_OUTPUT | AT91_PINCTRL_OUTPUT_VAL(0))>;
+ };
+ };
};
dbgu: serial@fffff200 {
@@ -119,6 +126,19 @@
wp-gpios = <&pioA 17 GPIO_ACTIVE_HIGH>;
};
};
+
+ spi0: spi@fffe0000 {
+ pinctrl-0 = <&pinctrl_spi0 &pinctrl_spi0_cs0>;
+ cs-gpios = <&pioA 3 GPIO_ACTIVE_HIGH>, <0>,
+ <0>, <0>;
+ status = "okay";
+
+ mtd_dataflash@0 {
+ compatible = "atmel,at45",
"atmel,dataflash";
+ spi-max-frequency = <15000000>;
+ reg = <0>;
+ };
+ };
};
usb0: ohci@00300000 {
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
