Hello,
I'm using an ASR1001 Cisco for CGN (NAT444 and NAT64). The ASR1001 sends
logs with netflow and I can read it with the method described here
(http://wiki.pmacct.net/OfficialExamples), section 17. To read them, I
use pmacct 1.5.0RC2 (in fact, nfacctd).
For NAT444, everything is good, I got records as :
100.96.0.10 58776 [PUB_IP_1]
18782 2 2014-03-21
17:14:53.651000000 0 0
However, here is what I get with NAT64 :
0.0.0.0 51056 [PUB_IP_2]
1029 2 2014-03-21
17:14:53.574000000 0 0
I should get an IPv6 address instead of "0.0.0.0".
Note : I've built pmacct with --enable-ipv6
Do you have any hints about it ? Did I miss something ?
Thank you very much,
Regards,
Grégoire Leroy
_______________________________________________
pmacct-discussion mailing list
http://www.pmacct.net/#mailinglists