[Elecraft] K3 Transmit thru Line-In

2009-03-05 Thread Bud Governale, W3LL
I can't get any transmit audio via the Line-In connector. Connecting the Mic cable to the rear panel MIC connection produces good transmit power and audio. I know audio is coming from the sound card output because it also drives the computer speaker via its line in connection. I tried moving

Re: [Elecraft] K3 Transmit thru Line-In

2009-03-05 Thread Eric Scace K3NA
Did you set the Line In gain control to a value 0? on 09 Mar 05 10:43 Bud Governale, W3LL said the following: I can't get any transmit audio via the Line-In connector. Connecting the Mic cable to the rear panel MIC connection produces good transmit power and audio. I know audio is coming

Re: [Elecraft] K3 Transmit thru Line-In

2009-03-05 Thread Richard Ferch
Bud, I suspect your Line In level control may be set to zero. This cannot be adjusted while MIC+LIN is on. In order to adjust the Line In level, you have to set MAIN:MIC SEL to LINE IN. Then adjust the LINE IN level using the MIC control. After the Line In level is set to an appropriate level,

Re: [Elecraft] K3 Transmit thru Line-In

2009-03-05 Thread The Smiths
Dont bother with the line in unless you plan to use DATA mode. The jack doesn't seem to activate unless you're in the data mode. Or at least that's what I've found. Turn your gain back up, switch to data mode, then put the VOX on, and try again. I think that you'll find it works just fine.

Re: [Elecraft] K3 Transmit thru Line-In

2009-03-05 Thread Bob Tellefsen
comes from the laptop. 3 Bob N6WG - Original Message - From: The Smiths notforc...@hotmail.com To: Elecraft Reflector elecraft@mailman.qth.net Sent: Thursday, March 05, 2009 9:58 AM Subject: Re: [Elecraft] K3 Transmit thru Line-In Dont bother with the line in unless you plan to use

Re: [Elecraft] K3 Transmit thru Line-In

2009-03-05 Thread Grant Youngman
Huh? Line in works just fine for voice modes, as it's supposed to. You just have to select it and turn up the gain. Grant/NQ5T On Mar 5, 2009, at 11:58 AM, The Smiths wrote: Dont bother with the line in unless you plan to use DATA mode. The jack doesn't seem to activate unless you're

Re: [Elecraft] K3 Transmit thru Line-In

2009-03-05 Thread K2MK
Hi Mike: LINE-IN with or without VOX works fine here in DATA mode or SSB. But the level settings are not the same between AFSK in DATA (from MixW) and voice in SSB (from WriteLog). The Smiths Thu, 05 Mar 2009 09:58:35 -0800 Dont bother with the line in unless you plan to use DATA mode. The