The audio level differences remind me of a situation I had w/ a DSP
board, but had nothing to do w/ the Rev D upgrade.
Your original DSP board may have been defective. I had to replace one
of my K3's DSP board a while back as I was noticing a significant audio
level difference between the two
Makes me wonder if someone else will eventually end up with my old,
defective board. I just figured it was caused by the change in capacitor
values but what you're saying makes more sense.
BTW: Did you notice any increase of bass with this new board? I can't say
that I noticed any change.
In the industry at large, refurbished boards tend to have a
significantly lower failure rate than new boards. The public's
reticence to using reworked electronics that aren't straight from
fabrication is based on an urban myth. Refurbished electronic items
are by and large a very good value.
Guy,
In support of what you are communicating, I have been purchasing
refurbished (and off-lease) IBM computers for some time now. They are
always quite reliable and last me longer than other new computers that I
have purchased in the past.
The refurbished K3 DSP boards carry the full 1 year
How far down dB-wise is the 3rd harmonic?
On Sat, Jan 9, 2010 at 11:41 AM, Steve Ellington n...@carolina.rr.com wrote:
The installation of the Rev D DSP board went smoothly. I updated the
firmware and all is well.
The first thing I noticed was how much louder the headphones (Bose 32 ohm)
, January 09, 2010 11:50 AM
Subject: Re: [Elecraft] K3 New DSP board installed
How far down dB-wise is the 3rd harmonic?
On Sat, Jan 9, 2010 at 11:41 AM, Steve Ellington n...@carolina.rr.com
wrote:
The installation of the Rev D DSP board went smoothly. I updated the
firmware and all is well
Is the spur at 3.9 KHz gone?
--- On Sat, 1/9/10, Steve Ellington n...@carolina.rr.com wrote:
From: Steve Ellington n...@carolina.rr.com
Subject: [Elecraft] K3 New DSP board installed
To: Elecraft@mailman.qth.net
Date: Saturday, January 9, 2010, 9:41 AM
The installation of the Rev D DSP board
How about the TX side. AFAI understand it should do
things to TX audio.
/ Jim SM2EKM
-
Wes Stewart wrote:
Is the spur at 3.9 KHz gone?
--- On Sat, 1/9/10, Steve Ellington n...@carolina.rr.com wrote:
From: Steve Ellington n...@carolina.rr.com
Subject: [Elecraft] K3 New
elecraft@mailman.qth.net
Sent: Saturday, January 09, 2010 4:51 PM
Subject: Re: [Elecraft] K3 New DSP board installed
How about the TX side. AFAI understand it should do
things to TX audio.
__
Elecraft mailing list
Home: http
9 matches
Mail list logo