Channel hopping doesn't seem to offer anything useful to me. It would
have been nice if rotating VFO A not only displayed the frequency stored
but instantly assigned it to a VFO so the K3 could be used in the same
manner as a crystal controlled transceiver (without having to press M-V
again).
-Original Message-
From: Tom Doligalski [mailto:[EMAIL PROTECTED]
Sent: Sunday, June 08, 2008 7:29 AM
To: 'Dave G4AON'
Subject: RE: [Elecraft] K3 Beta Firmware Revision 2.02
I think you'll find that Channel Hopping on the K3 will work just as you
wish try this:
1. Load your
Finally found time for an update (this one, 2.02), and the gain
discrepancy between the FIR and IIR filters seems to have gone away
somewhere in the recent flurry of releases - at least in this version
I can't detect any difference moving between 150 and 100 Hz filters
with FIR enabled.
Bob NW8L
K3 beta-test firmware revision 2.02 is now available. It includes one
new feature (channel hopping, especially useful on 60 meters) and a
correction to CW/VOX behavior. Full details appear below.
For instructions on how to obtain and load beta firmware, please see:
Interesting, since MCU version 2.00 already,it is possible to use the
front panel buttons RX ant, PRE, ATT, XFIL AFX while in TX Mode!
The filter settings cannot be yet changed however.
Very useful addition, however no feedback is provided when a key is
pressed during TX - it all happens when
5 matches
Mail list logo