Re: CS>silver rods

[Acmeair]

those melamine pads are made of something that reacts to the item cleaned.  why the concern about doing all this cleaning of your  .999 or .9999 silver rods.  for about 5 years, just cleaning with a paper towell has been satisfactory.      jim


May 19, 2010 11:10:16 AM, silver-list@eskimo.com wrote:

I thought I would update everyone on the saga of my weird results since using the melamine pad on the silver rods. I cleaned them using H202 and then distilled water, but the CS still took seven hours or so and the generator wouldn't turn off and the CS ppm measured only 4 (using a TDS) I then put the rods into the sonic cleaner which I bought to make the liposomal Vit C and you could see the cloud of grey float off of the rods. However, the CS still wasn't right i.e. it was still taking hours and hours to do and then going yellow. I then decided to try direct current instead of using reverse polarity and I got all this ghostly filaments like ectoplasm is said to be. Again, this went yellow and when I put in some home-made 3% H202 it went a murky green/grey. After putting in more and more H202 it finally went sort of silvery with very little tyndall and loads of air bubbles. The ppm was then 3. Finally, I decided to give up with those rods and have had to use my new ones. The result is perfect, clear CS about 8 to 10ppm. Moral of story: dont use melamine pads on silver rods! dee

--
The Silver List is a moderated forum for discussing Colloidal Silver.
Rules and Instructions: http://www.silverlist.org

Unsubscribe:

Archives:
http://www.mail-archive.com/silver-list@eskimo.com/maillist.html

Off-Topic discussions:
List Owner: Mike Devour

-- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: Archives: http://www.mail-archive.com/silver-list@eskimo.com/maillist.html Off-Topic discussions: List Owner: Mike Devour