Had a cabling issue from when I dissembled it earlier. Sensor is now detected. I have updated the GDoc with the new outputs: https://docs.google.com/document/d/1WfGlWGk0A7zLgAl1EptMntTKoKLJLodron0P0zYcpB4/edit?usp=sharing
Firmware s 8.2.15. I deleted /etc/autocampars.xml and went to http://10.23.33.9/index.php?site=autocampars.php again to re-generate it which just resulted in an error message. The error message is also in the GDoc. I should also note it is still generating the same 1x1 bimg. Thanks, Linden Mills-Connery Zone4 Team <https://zone4.ca/contact/> 205-820 Main Street Canmore, AB, T1W2B7 403-401-7215 On 17 August 2018 at 15:03, Oleg <support-list@support.elphel.com> wrote: > So, it does not detect the sensor. > What's the firmware? > >> # cat /etc/issue > > > You might have tried another cable. > If it's the board - I would check the connector first. Then the power, > then i2c bus. > Links to schematics are under the diagrams here > <https://wiki.elphel.com/wiki/10353>. > > Regards, > Oleg > > On Fri, Aug 17, 2018 at 1:41 PM Linden @ Zone4 <lin...@zone4.ca> wrote: > >> Thanks Oleg. >> >> 000E64081C8B >> Here is the requested diagnostics: >> https://docs.google.com/document/d/1WfGlWGk0A7zLgAl1EptMntTKoKLJL >> odron0P0zYcpB4/edit?usp=sharing >> >> 000E64081CA1 >> I will send that one back to you. Will wait until we know if 000E64081C8B >> needs to go back as well or if I can resolve the issue here. >> >> The one with the color tinting is behaving much better. >> >> Thanks, >> _______________________________________________ >> Support-list mailing list >> Support-list@support.elphel.com >> http://support.elphel.com/mailman/listinfo/support-list_ >> support.elphel.com > > Best regards, > Oleg Dzhimiev > Electronics Engineer > phone: +1 801 783 5555 x124 > Elphel, Inc. >
_______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com