Several people on the TekScopes/Tekscopes2 forums went through this a
while back. It turned out that ribbon cable appropriate for this
application was either not available or too expensive.
John Griessen made a set of PWBs and sold kits consisting of a PWB pair,
a connector pair and a set of pre-cut and pre-stripped wires. I believe
he sold all the kits.
I built one of mine and it works well. I use it with a TM-501 as a
stand-alone test setup for single-wide plug-ins.
DaveD
On 8/3/2014 11:54 PM, Mark Sims wrote:
I think a cable made from ribbon cable edge connectors would be the
easiest/cheapest way to extend the GPIB connector.
------------------------
Have you thought about making extensions for the smaller connector used to
distribute GPIB in the 5000 series?
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.