Am I right in thinking that two of these connector/cables would give the
full facilities on the 5000 series units.
Roy
-----Original Message-----
From: Dave Daniel
Sent: Monday, August 04, 2014 4:02 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Tektronix TM500 extender cable kit
Several people on the TekScopes/Tekscopes2 forums went through this a
while back. It turned out that ribbon cable appropriate for this
application was either not available or too expensive.
John Griessen made a set of PWBs and sold kits consisting of a PWB pair,
a connector pair and a set of pre-cut and pre-stripped wires. I believe
he sold all the kits.
I built one of mine and it works well. I use it with a TM-501 as a
stand-alone test setup for single-wide plug-ins.
DaveD
On 8/3/2014 11:54 PM, Mark Sims wrote:
I think a cable made from ribbon cable edge connectors would be the
easiest/cheapest way to extend the GPIB connector.
------------------------
Have you thought about making extensions for the smaller connector used
to distribute GPIB in the 5000 series?
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
