[Vo]:Rossi heat exchanger fitting

[Horace Heffner]

Attached is a jpg of the fitting for the hot end of the Rossi heat  
exchanger.  The finger points to where the Tout themocouple was  
located.  The other side of this big brass fitting was the entry  
point for the steam/water from the E-cat.

You can see white streak marks on the tape both sides of the  
fitting.  I wonder if those are "footprints" of the thermocouples used.

Best regards,

Horace Heffner
http://www.mtaonline.net/~hheffner/



<<inline: Tout.jpg>>