I am trying to get my Linksys USB Network Adapter with Wi-Fi finder
Linksys WUSBF54G 13b1:0024 to work with zd1211rw. Previously I've had
success version getting it to work with the old zd1211 driver.
I'm running Ubuntu feisty, which has kernel 2.6.19-7.
zd1211rw is snapshot 2006-12-14, with an edited zd_usb.c with a new
{USB_DEVICE(0x13b1, 0x0024), .driver_info = DEVICE_ZD1211B}
I seem to get the usb adapter recognized, but the Bit Rate is only 1
Mb/s and I can't get an dhcp offer. I tried to set another bit rate with
iwconfig (sudo iwconfig eth1 rate 11M), but it doesn't change. The
output of iwconfig looks the same next time.
Any ideas how I can get further or what I'm doing wrong?
/Henrik Hjelte
dmesg:
[ 1047.992000] usb 3-3: new high speed USB device
using ehci_hcd and address 8
[ 1048.124000] usb 3-3: configuration #1 chosen from 1
choice
[ 1048.156000] usb 3-3: firmware version 0x4810 and
device bootcode version 0x4802 differ
[ 1048.264000] zd1211rw 3-3:1.0: firmware version 4725
[ 1048.308000] zd1211rw 3-3:1.0: zd1211b chip 13b1:0024 v4802
high00-14-bf AL2230_RF pa0 ----
[ 1048.308000] zd1211rw 3-3:1.0: eth1
[ 1048.432000] ADDRCONF(NETDEV_UP): eth1: link is not
ready
iwconfig:
eth1 IEEE 802.11b/g ESSID:"O" Nickname:"zd1211"
Mode:Managed Frequency:2.412 GHz Access
Point: Invalid
Bit Rate=1 Mb/s
Link Quality:0 Signal level:0 Noise
level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx
invalid frag:0
Tx excessive retries:0 Invalid misc:0
Missed beacon:0
-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys - and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________
Zd1211-devs mailing list - http://zd1211.ath.cx/
Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs
