Tapani Sysimetsä wrote: > On 28/03/10 16:03, Frank Smith wrote: > >> HI All >> It seems I cannot use the select move/ranges to remove a small error >> in a guitar piece >> Was fine the other day. >> I assume I have set some global thing and it seems to want to snap to >> the guides only. >> > > Select "No Grid" from the menu under the primary clock? > > Tapani
Pardon, I just replied because of how to avoid noise for single coil guitars. Because of the topic this is my opinion: I wouldn't delete noise at passages were the guitar isn't played, if I have this problem I just fade out the noise a little bit. Noise could be too loud, but removing noise in passages were the guitar isn't played completely IMO isn't good. I do make noise in passages were the guitar isn't played less loud, but I don't cancel it completely, to avoid that there is a audible blending. Keep in mind that the noise also is audible when the guitar is played. Noise isn't bad at all cost. IMO it's better to keep some decreased noise also in passages were the guitar isn't played. _______________________________________________ 64studio-users mailing list [email protected] http://lists.64studio.com/mailman/listinfo/64studio-users
