Ralf Mardorf wrote: > Tapani Sysimetsä wrote: > >> On 28/03/10 16:03, Frank Smith wrote: >> >> >>> HI All >>> It seems I cannot use the select move/ranges to remove a small error >>> in a guitar piece >>> Was fine the other day. >>> I assume I have set some global thing and it seems to want to snap to >>> the guides only. >>> >>> >> Select "No Grid" from the menu under the primary clock? >> >> Tapani >> > > Pardon, I just replied because of how to avoid noise for single coil > guitars. Because of the topic this is my opinion: I wouldn't delete > noise at passages were the guitar isn't played, if I have this problem I > just fade out the noise a little bit. Noise could be too loud, but > removing noise in passages were the guitar isn't played completely IMO > isn't good. I do make noise in passages were the guitar isn't played > less loud, but I don't cancel it completely, to avoid that there is a > audible blending. Keep in mind that the noise also is audible when the > guitar is played. Noise isn't bad at all cost. IMO it's better to keep > some decreased noise also in passages were the guitar isn't played. >
Hi Ralf, you may well be right regarding the noise. Depends on the case and what one wants. I just offered my 2 cents for the snapping problem, no offense. Greetings, Tapani _______________________________________________ 64studio-users mailing list [email protected] http://lists.64studio.com/mailman/listinfo/64studio-users
