Take a look at a product called futurepath - it’s a 7 or more micro duct in one larger duct. You can dig it up, cut into the outer duct, pull out one of the inner ducts and cut it. Feed that from both ends.
Mark Radabaugh Amplex 22690 Pemberville Rd Luckey, OH 43447 419-261-5996 > On Sep 21, 2018, at 7:42 PM, Carl Peterson <[email protected]> wrote: > > > Something that might get work would be to do a 19 way 8.5/6 or 10/6 microduct > fed from both ends. Cut 3-4' trenches near the corner of each block of four > units and then bore through and pull back the 19 way. Pull the 19 way up in > each trench just enough to splice in four drop ducts and route them just > under the fence for each lot and CAP them leaving them underground. Then > push the 19 way back down and cover it. When you want to do an install, just > dig up the drop duct in the corner of the customers lot, couple on a duct, > run it to their house and push/pull a drop through it. > > Might be easier to just pull in a larger duct, expose it with the trenches, > cut out a 3-4' section in each trench, pull in the 19 way, and then break out > the drop ducts. That way you don't have to hit your trench exactly and will > know that you can pull up enough slack and then push it back into the ground. > > > No peds or hand holes in anyone's yards and when you need to do an install > you only need to access the customers yard in question. > >> On Sep 21, 2018, at 6:19 PM, Carl Peterson <[email protected]> >> wrote: >> >> Are you going to get an easement from each homeowner? >> >> How do you deal with the fences short of two bores and a HH or slack loop in >> every back yard? >> >> >> I'm in FL this week trying to get a back side of the house FTTH build back >> on track and if I had to do it again I think I would have kept the mainline >> in front of the houses with laterals between them back to hand holes in the >> back. Ran into way too much unmarked crap in the back. >> >>> On Sep 21, 2018, at 5:43 PM, <[email protected]> <[email protected]> wrote: >>> >>> Lets say you are going into a neighborhood like this. I could bore down >>> the back fences and put a duct from one end to the other. >>> Then perhaps dig the duct up in the middle of each lot at their back fence >>> and pull a slack loop up into a pedestal. >>> Or just direct bury the slack loop for now. >>> >>> Later cut in a splitter if I wanted to do PON. Trying to avoid a bunch of >>> handholes etc. >>> >>> <image[1].png> >>> >>> >>> -- >>> AF mailing list >>> [email protected] >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
