hrmmm.....
--
Josh Reynolds
CIO, SPITwSPOTS
www.spitwspots.com
On 02/26/2015 03:48 PM, Josh Luthman wrote:
If you have them self install, use an ip reveal and when they tell you
it, add their mac to Powercode.
Bottom left corner here: portal.inxwireless.com
<http://portal.inxwireless.com>
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Feb 26, 2015 6:45 PM, "Josh Reynolds" <[email protected]
<mailto:[email protected]>> wrote:
The customer router is not ours, it's whatever the customer has.
It's a problem because there isn't a specific piece of hardware
that we are tracking under the customer's account. Because there
isn't a piece of hardware, there's not an IP associated with the
customer.
--
Josh Reynolds
CIO, SPITwSPOTS
www.spitwspots.com <http://www.spitwspots.com>
On 02/26/2015 03:43 PM, Chris Fabien wrote:
So does the cpe router end up getting one op address per
account? Why is this a problem for powercode?
On Feb 26, 2015 7:39 PM, "Josh Reynolds" <[email protected]
<mailto:[email protected]>> wrote:
Hey guys...
We've got several different MDU setups. Our most common is an
ethernet cable handoff to an apartment that is a vlan into a
router handing out a single ip.
This presents a monitoring / shaping / auto-disconnect
problem for us with powercode.
Anybody else encountered this? How did you work around it?
Thanks
--
--
Josh Reynolds
CIO, SPITwSPOTS
www.spitwspots.com <http://www.spitwspots.com>
