I've only had one 2.4 lockup and it was definitely an Ethernet issue. It would primarily happen in rain (probably a damaged cable somewhere). I tried replacing ends and that didn't change it. One night it wouldn't come back (it would usually go down and come back up within a couple minutes) so I forced the switch to 10FDX. That seemed to work for a week or so. Yesterday we got rain again and that AP went down again so I went and ran a new line and replaced the AP. Now all is good.
On Sat, May 16, 2015 at 9:27 AM, CBB - Jay Fuller <[email protected] > wrote: > > on three different radios on two towers? :) > > > ----- Original Message ----- > *From:* Josh Luthman <[email protected]> > *To:* [email protected] > *Sent:* Saturday, May 16, 2015 9:34 AM > *Subject:* Re: [AFMUG] epmp lockups > > Bad Ethernet port? Replace it. > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > On May 16, 2015 10:08 AM, "CBB - Jay Fuller" <[email protected]> > wrote: > >> >> We're running some EPMP 2.4 - recently, we've seen a higher number of >> lockups than normal. I would say in the 6 months or so we've been running >> it, i've certainly seen at least one lockup with each access point. >> >> A few questions - >> >> Is anyone else seeing this, or are we just lucky? >> >> If so, is there a firmware version you see this less? >> >> We have rebooters at most of the sites it's occurring but at least one >> site I know doesn't have one. >> (i know cause i had someone out there at 1:30 this morning and now i'm >> about to go out there!) >> >> Thanks! >> -jf >> >> >
