Bah! Too much coffee. I don't have any ePMP. I just saw 2.4GHz. Ours are all ubnt and do not lockup. Sorry for the confusion.
On Sat, May 16, 2015 at 9:57 AM, Jeremy <[email protected]> wrote: > I've only had one 2.4 lockup and it was definitely an Ethernet issue. It > would primarily happen in rain (probably a damaged cable somewhere). I > tried replacing ends and that didn't change it. One night it wouldn't come > back (it would usually go down and come back up within a couple minutes) so > I forced the switch to 10FDX. That seemed to work for a week or so. > Yesterday we got rain again and that AP went down again so I went and ran a > new line and replaced the AP. Now all is good. > > On Sat, May 16, 2015 at 9:27 AM, CBB - Jay Fuller < > [email protected]> wrote: > >> >> on three different radios on two towers? :) >> >> >> ----- Original Message ----- >> *From:* Josh Luthman <[email protected]> >> *To:* [email protected] >> *Sent:* Saturday, May 16, 2015 9:34 AM >> *Subject:* Re: [AFMUG] epmp lockups >> >> Bad Ethernet port? Replace it. >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> On May 16, 2015 10:08 AM, "CBB - Jay Fuller" <[email protected]> >> wrote: >> >>> >>> We're running some EPMP 2.4 - recently, we've seen a higher number of >>> lockups than normal. I would say in the 6 months or so we've been running >>> it, i've certainly seen at least one lockup with each access point. >>> >>> A few questions - >>> >>> Is anyone else seeing this, or are we just lucky? >>> >>> If so, is there a firmware version you see this less? >>> >>> We have rebooters at most of the sites it's occurring but at least one >>> site I know doesn't have one. >>> (i know cause i had someone out there at 1:30 this morning and now i'm >>> about to go out there!) >>> >>> Thanks! >>> -jf >>> >>> >> >
