I have two on my desk that I submitted support case requests for and
haven't got a response yet. You want me to drive them up to Rolling
Meadows? :)
The 5GHz SM shows RF calibration failure and ADI communication failure.
The 3GHz SM shows only RF calibration failure. They both reboot shortly
after starting to scan. I think I might have another 5GHz in my WTF pile
too, have to check tomorrow.
On 8/6/2015 11:37 PM, Rajesh Vijayakumar wrote:
We are waiting for the RMA'd units to reach us, so we can look at what
is going on. I am told we should get at least one unit on Monday. I
will provide more details as soon as possible. I am sorry about the
trouble this is causing.
Rajesh Vijayakumar
Cambium Networks
On Thu, Aug 6, 2015 at 1:14 PM, Brian Sullivan
<[email protected] <mailto:[email protected]>> wrote:
We have had a few.
On 8/6/2015 12:12 PM, timothy steele wrote:
yeah same here 1 was a tower climb.. was hoping someone knew
whats making this happen as they work fine out of the box then
die later
On Thu, Aug 6, 2015 at 12:16 PM, George Skorup <[email protected]
<mailto:[email protected]>> wrote:
Had a couple 3GHz and 5GHz SMs last week as well. Replace and
RMA is the only solution.
On 8/6/2015 11:11 AM, timothy steele wrote:
we have had 2 brand new 5ghz 450's out of the blue have the
RF die and show in re letters
RF Calibration Failure
ADI Catalina R1 chip not supported!
They both where running 13.2.1 and both where installed for
a week or so before they stopped running tired defaulting
both and upgrading firmware on both did not work they also
randomly reboot the 2 where installed a 2hr drive apart
connected to diffrent towers
anyone have any clue whats going on here??
Thanks
