Not to get off topic here, but the two 5ch PDUs I just got show 35.5-ish
volts on the master input... with no supply connected. And the status
LED doesn't flash like it normally would if it sees no/low voltage on
the master. Seems strange. Are these bad or should I just not worry
about it? They were both showing that before and after I updated the
firmware, BTW. I only have one other one from months ago for a mockup
that I never ended up using and it acts normally. It shows like 1.2
volts on the input with nothing feeding it and the status LED does flash
5 or 6 times.
On 8/18/2015 4:54 PM, Forrest Christian (List Account) wrote:
If you've bought at least 25, yes.
I'm in classes all this week, and wasn't feeling well last night so I
shirked my ticket duties last night.
I'll try to get back to you tonight after classes.
On Aug 18, 2015 2:25 PM, "Adam Moffett" <[email protected]
<mailto:[email protected]>> wrote:
So....I've bought half the units sold?
You should look for my email to custsvc from yesterday. I would
be looking for 60 units at neg48.
On 8/18/2015 5:11 PM, Forrest Christian (List Account) wrote:
The pdu was designed to be able to be built for neg48 as well,
but relies on expansion bus power to power it. This means that
if you reboot the base unit, the pdu and the devices attached to
it will also reboot. There are some messy ways we can bring this
power in to avoid this.
Because of this, we've never officially released the neg48
version of this. Eventually my intent is to add an additional
circuit to fix this, but since we've shipped less than 50 of
these it isn't a high priority.
So, If you want a couple which do neg48 we can build them since
it's just a couple of part swaps . Probably would need a week or two.
I like the packetflux PDU, but I need to switch -48 loads. Does
anybody have any suggestions?
Forrest.....if you make it I will buy it.
