I'm 99% sure that this reading was working before as well, or at least at some point.
I am very particular about checking the overcurrent protection on these so I can pretty much guarantee that is fine. The voltage is sort of a 'bonus feature' so I'm a bit less particular about it - but I know it is on the assembly verification for the product, which probably means that it was working before, and there hasn't been any new pdu's assembled since I updated the firmware. -forrest On Tue, Aug 18, 2015 at 7:49 PM, Adam Moffett <[email protected]> wrote: > I'm pretty sure mine were reading the correct voltages until after the > software update. Now the 24v input reads 46, and the 48v input reads 61. > > > Hardware or software? Hopefully these can be fixed in software because I > need to get them deployed. Does this mean the overcurrent protection won't > work right either? These are going to be a long drive away and I don't want > to have them not working right and have to go fix them. > > I'm remembering something... The two new PDUs came with the latest > firmware, but I did have to update the 2-relay / 3-switch modules and the > older PDU module. Not sure if the old PDU shows the 35 volts now with the > updated firmware. I can check again tomorrow. > > On 8/18/2015 6:51 PM, Forrest Christian (List Account) wrote: > > I've heard twice now weirdness with that voltage reading. Both in the > last week. I haven't had a chance to get it on the bench to test. > > I'm guessing that I'm reading the wrong adc input somehow. > On Aug 18, 2015 4:00 PM, "George Skorup" <[email protected]> wrote: > >> Not to get off topic here, but the two 5ch PDUs I just got show 35.5-ish >> volts on the master input... with no supply connected. And the status LED >> doesn't flash like it normally would if it sees no/low voltage on the >> master. Seems strange. Are these bad or should I just not worry about it? >> They were both showing that before and after I updated the firmware, BTW. I >> only have one other one from months ago for a mockup that I never ended up >> using and it acts normally. It shows like 1.2 volts on the input with >> nothing feeding it and the status LED does flash 5 or 6 times. >> > > > -- *Forrest Christian* *CEO**, PacketFlux Technologies, Inc.* Tel: 406-449-3345 | Address: 3577 Countryside Road, Helena, MT 59602 [email protected] | http://www.packetflux.com <http://www.linkedin.com/in/fwchristian> <http://facebook.com/packetflux> <http://twitter.com/@packetflux>
