Oh whoops. I didn't realize that was the cat5 coupler. Try a different card? Would grounding be relevant to it?
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Fri, Apr 29, 2016 at 2:07 PM, George Skorup <[email protected]> wrote: > He said it works with the SS removed from the path, so I would assume he > has everything configured properly. > > I imagine that Cambium implemented the same functionality into the 450i > that they did with the 450 AP. If it doesn't see data on all four pairs, > then it drops back to 10/100 auto after a few seconds. > > On 4/29/2016 1:01 PM, Josh Luthman wrote: > > Also make sure the config of the 450i is set to gig. I want to say the > default is auto 100/10 full/half > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Fri, Apr 29, 2016 at 2:00 PM, George Skorup <[email protected]> wrote: > >> Are you absolutely sure it's a GIGE-APC-HV? Should be printed GIGE-APC on >> the board and then they write HV on the back side of the handle. >> >> I have gigabit running through lots of them and they work fine. But now >> that I think about it, those are only AirFiber's and licensed radios. No >> 450 APs doing GigE + sync-over-power yet. >> >> On 4/29/2016 11:03 AM, Wireless Administrator wrote: >> >> We�re not able to get our Cambium 450i radio�s Ethernet Interface to >> run at Gigabit speed.� Our setup is as follows: Gigabit switch (Tried >> several brands) �14� Cat6 Patch �Gigabit Sync injector (48V) � >> 35� Best-tronics Cat5 Shielded � 800-800-GIGE-APC-HV � 80� >> Best-tronics Cat5 Shielded � Cambium 450i It works without the >> 800-800-GIGE-APC-HV. (Cat5 Coupler). Anyone ���. � Steve B. � >> � >> >> � >> >> >> > >
