We have moved many of the STL links here to
IP based links. (Licensed and not)
Less cost, better throughput and easier maint.
Mitch Koep
218-851-8689 cell
On 04/13/2017 10:10 AM, Jaime Solorza wrote:
yes it is....I recommended replacing everything at mountain location.
I hope to get in good with these folks as pay is good and they need
allot of maintenance work based on what I observed.
Jaime Solorza
Wireless Systems Architect
915-861-1390
On Thu, Apr 13, 2017 at 9:01 AM, Chuck McCown <[email protected]
<mailto:[email protected]>> wrote:
Splitter with pigtail not connected to anything will definitely
cause a suck out at some frequency(s). Could be the whole problem.
*From:* Jaime Solorza
*Sent:* Wednesday, April 12, 2017 9:35 PM
*To:* Animal Farm
*Subject:* [AFMUG] STL interference work
Got hired to help station RF guy with suspected
interference....950.00MHz 7.1 mile link using Scala PR-18
reflectors on each end.... Signal should be in the -50s but they
were getting -90dBm...Check alignment...Good, checked cabling and
connectors on TX side on ground level, good.... Drove up to Lower
Comanche site on mountain....Found a splitter with a pigtail not
connected to anything..2nd picture, and old bad cable 3rd
picture....Will replace cable and antenna this week.
--
Mitch Koep
A Better Wireless
218-851-8689 cell
