I have done that for Clear Channel...Using Harris STL boxed... On Apr 13, 2017 9:20 AM, "Mitch Koep" <[email protected]> wrote:
> We have moved many of the STL links here to > > IP based links. (Licensed and not) > > Less cost, better throughput and easier maint. > > Mitch Koep > > 218-851-8689 <(218)%20851-8689> cell > > > > On 04/13/2017 10:10 AM, Jaime Solorza wrote: > > yes it is....I recommended replacing everything at mountain location. I > hope to get in good with these folks as pay is good and they need allot of > maintenance work based on what I observed. > > Jaime Solorza > Wireless Systems Architect > 915-861-1390 <(915)%20861-1390> > > On Thu, Apr 13, 2017 at 9:01 AM, Chuck McCown <[email protected]> wrote: > >> Splitter with pigtail not connected to anything will definitely cause a >> suck out at some frequency(s). Could be the whole problem. >> >> *From:* Jaime Solorza >> *Sent:* Wednesday, April 12, 2017 9:35 PM >> *To:* Animal Farm >> *Subject:* [AFMUG] STL interference work >> >> Got hired to help station RF guy with suspected >> interference....950.00MHz 7.1 mile link using Scala PR-18 reflectors on >> each end.... Signal should be in the -50s but they were getting >> -90dBm...Check alignment...Good, checked cabling and connectors on TX side >> on ground level, good.... Drove up to Lower Comanche site on >> mountain....Found a splitter with a pigtail not connected to anything..2nd >> picture, and old bad cable 3rd picture....Will replace cable and antenna >> this week. >> > > > -- > Mitch Koep > > A Better Wireless218-851-8689 <(218)%20851-8689> cell > >
