I have never seen an in wall AP with pass through RJ11, only an active RJ45 port for a computer or voip phone for example. On Thu, May 4, 2017 at 5:26 PM Carl Peterson <[email protected]> wrote:
> In-Wall AP. In this case the UBNT UAP-AC-IW. A lot of in wall access > points have an RJ11 pass through for phones but being UBNT, this one > doesn't. Looking for something like the attached image, except more like > just the outer ring. with an empty center so I can mount the in wall AP on > top of it and pass the phone connection out the side or bottom. > > [image: Inline image 1] > > On Thu, May 4, 2017 at 11:20 AM, Chuck McCown <[email protected]> wrote: > >> Not clear, in wall AP or in wall ATA? >> I would think a wall plate with both RJ45 and RJ11 on it. >> >> *From:* Carl Peterson >> *Sent:* Thursday, May 04, 2017 8:37 AM >> *To:* [email protected] >> *Subject:* [AFMUG] Phone line passthrough for in-wall AP >> >> Looking at installing a few hundred in wall APs somewhere where they are >> still using the phone lines. There is currently Cat5 lines, one phone, one >> data, run to a single low voltage box. Rather then having to cut and >> install a new low voltage frame, does anyone know of something like an >> extension ring with an RJ11 port on the side? Seems simple and I feel like >> I have seen them before but can't seem to find anything like it. >> > > > > -- > > Carl Peterson > > *PORT NETWORKS* > > 401 E Pratt St, Ste 2553 > > Baltimore, MD 21202 > > (410) 637-3707 > -- Darin Steffl Minnesota WiFi www.mnwifi.com 507-634-WiFi <http://www.facebook.com/minnesotawifi> Like us on Facebook <http://www.facebook.com/minnesotawifi>
