I don't have a single P10 or P11 FSK AP that has UGPS power control on
the config page. Perhaps it's just always on?
On 6/15/2017 9:35 AM, Forrest Christian (List Account) wrote:
AFAIK All semi-modern fsk radios provide uGPS power. Just connect the
radio and box together and turn on uGPS power in the radio. Use
whatever cable cambium recommends for a uGPS probably just a 6p6c
straight through cable, although it might make sense to skip the
factory reset pin.
On Jun 15, 2017 9:19 AM, "Paul McCall" <[email protected]
<mailto:[email protected]>> wrote:
Hmmmm….. let me try again.
I have a single FSK AP that is getting powered/ethernet
successfully connected to a UBNT S16. I need to get sync to that
radio. I want to power the SB Junior Timing Port Version by
making a cable that I can connect to the S16 that will connect to
one of the SBJTP timing ports to power it up.
Unless that ALL FSKs timing ports actually would provide the power
needed to power up the SBJTV ? with a “standard” cable whatever
that means 😊
Paul
*From:* Af [mailto:[email protected]
<mailto:[email protected]>] *On Behalf Of *Forrest Christian
(List Account)
*Sent:* Thursday, June 15, 2017 10:08 AM
*To:* af <[email protected] <mailto:[email protected]>>
*Subject:* Re: [AFMUG] Powering a Syncbox Junior without a uGPS
type device
What type of fsk radio do you gave that doesn't do ups power?
On Jun 15, 2017 9:04 AM, "Paul McCall" <[email protected]
<mailto:[email protected]>> wrote:
Syncbox Junior Timing Port Version
*From:* Af [mailto:[email protected]
<mailto:[email protected]>] *On Behalf Of *Forrest
Christian (List Account)
*Sent:* Thursday, June 15, 2017 10:03 AM
*To:* af <[email protected] <mailto:[email protected]>>
*Subject:* Re: [AFMUG] Powering a Syncbox Junior without a
uGPS type device
Which syncbox?
On Jun 15, 2017 8:51 AM, "Paul McCall" <[email protected]
<mailto:[email protected]>> wrote:
Guys,
We need to providing timing on a single FSK AP and it is
fed up the tower through fiber to a UBNT S16. (so its
powering off the S16). I want to use one timing port to
output timing to the FSK (as normal) and one port to
receive power from the S16 and need to figure out the
pinout (wiring diagram) to make that happen.
Paul
Paul McCall, President
PDMNet, Inc. / Florida Broadband, Inc.
658 Old Dixie Highway
Vero Beach, FL 32962
772-564-6800 <tel:%28772%29%20564-6800>
[email protected] <mailto:[email protected]>
www.pdmnet.com <http://www.pdmnet.com>
www.floridabroadband.com <http://www.floridabroadband.com>
