Be interesting to see what kind of channels will be available if I build this
network. Got something 11 paths.
From: Mathew Howard
Sent: Tuesday, August 15, 2017 3:59 PM
To: af
Subject: Re: [AFMUG] AF-11x
Max channel bandwidth is 56mhz, but you should easily be able to get 250Mbps
out of a 40mhz channel... I'm not sure there's much point in going in narrower
than that. Actually, doing SISO at a 56mhz channel might make more sense, that
should get around 275mbps at 256qam (and a bit more if the link will do
1024qam, obviously), but then you'd only need a one polarity, so it may save a
bit on coordination, and you wouldn't need to buy the extra duplexers.
On Tue, Aug 15, 2017 at 1:34 PM, Chuck McCown <ch...@wbmfg.com> wrote:
What is a common channel BW? 40 MHz? I suppose it depends on congestion. I
only need about 250 Mbps so lower order modulation may be desirable and perhaps
narrower channels too.
From: Jeremy
Sent: Tuesday, August 15, 2017 10:54 AM
To: af@afmug.com
Subject: Re: [AFMUG] AF-11x
Of course, the exact configuration is based on your license and which
frequencies it is supposed to operate on. The above configuration is just an
example.
On Tue, Aug 15, 2017 at 10:53 AM, Jeremy <jeremysmi...@gmail.com> wrote:
They are like that, but 3x bigger. On top, the lid comes off and the
duplexers go beneath the cover. If your link is 'High' then you will want
'High' duplexers for both sides of the link (x4 total - two extra to purchase)
- they will go in a configuration like 1-3-3-1 on one side and 3-1-1-3 on the
other side.
On Tue, Aug 15, 2017 at 10:11 AM, Mathew Howard <mhoward...@gmail.com>
wrote:
They come with 1 duplexer (setup for SISO) - you need to buy the second
one separately to do MIMO. You do need to figure out what frequencies you're
going to be using before you buy the radios, since there are two different
duplexers, depending on which half of the band you're in.
You need one frequency pair on both polarities (for MIMO).
On Tue, Aug 15, 2017 at 10:52 AM, Chuck McCown <ch...@wbmfg.com> wrote:
Do they all come with two N connectors or do you have to pay more for
duplexers? Not quite sure how to buy or license. I guess you have to have two
pairs of frequencies? Or at the very least, both polarizations on the same
frequency?
Trying to collect some budgetary estimates on what my project is going
to cost.
