cold shrink tubing I suppose. Not sure if they make it that small.
------ Original Message ------
From: "Steve Jones" <[email protected]>
To: "[email protected]" <[email protected]>
Sent: 9/14/2017 4:52:42 PM
Subject: Re: [AFMUG] Small 5ghz antennas
you can use rfelements connectorized with the 2000 series or quickport
with the 1000 series, thats probably your smallest footprint solution.
if you find a clean way to weatherize the top of the 2000 AP with the
connectorized that doesnt involve mastic please update
On Thu, Sep 14, 2017 at 3:45 PM, Nate Burke <[email protected]> wrote:
I'm looking to install an EPMP AP where the subs (force 180's) are
only going to be about 100 yards away, and within a few degrees of
each other. There is an existing mount already installed on the AP
side, but it cannot handle something the size of a normal sector.
There is a bare FSK AP installed today, so that's the form factor I'm
replacing. Replacing the mount would be very difficult. Any
recommendations for small antennas for the EPMP line? There are other
EPMP Ap's at the site, so I would like to keep sync on the AP side,
otherwise I would just throw on a Force180 as an AP and be done.
