Silicone-rubber tape.
On 9/14/2017 4:05 PM, Adam Moffett wrote:
cold shrink tubing I suppose. Not sure if they make it that small.
------ Original Message ------
From: "Steve Jones" <[email protected]
<mailto:[email protected]>>
To: "[email protected]" <[email protected] <mailto:[email protected]>>
Sent: 9/14/2017 4:52:42 PM
Subject: Re: [AFMUG] Small 5ghz antennas
you can use rfelements connectorized with the 2000 series or
quickport with the 1000 series, thats probably your smallest
footprint solution.
if you find a clean way to weatherize the top of the 2000 AP with the
connectorized that doesnt involve mastic please update
On Thu, Sep 14, 2017 at 3:45 PM, Nate Burke <[email protected]
<mailto:[email protected]>> wrote:
I'm looking to install an EPMP AP where the subs (force 180's)
are only going to be about 100 yards away, and within a few
degrees of each other. There is an existing mount already
installed on the AP side, but it cannot handle something the size
of a normal sector. There is a bare FSK AP installed today, so
that's the form factor I'm replacing. Replacing the mount would
be very difficult. Any recommendations for small antennas for
the EPMP line? There are other EPMP Ap's at the site, so I would
like to keep sync on the AP side, otherwise I would just throw on
a Force180 as an AP and be done.
