I do not have a debug board. However, I have a slow MMC card and when
booting from Qi, I can see the debug message on the booting about the
waiting for card to init though I pass the param:
glamo_core.slow_memory=1. I do not get this error when booting from SD
card with Qi.
When I switched over to u-boot, I do not get the error either and the
system boots up ok.
It could be that the mmcinit() in Qi is done a lot earlier and it needs
a different way to indicate slow mmc.
Regards,
Vaidhy
Andy Green wrote:
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Somebody in the thread at some point said:
| Qi from Nand definitely has some problems. I found that booting from
| Nand does not pass the kernel parameters at all while U-boot does it
| correctly. However, Qi booting from sdcard works fine.
How did you conclude that it doesn't pass kernel parameters at all?
You can see the kernel parameter string it's going to use with a debug
board, is that what you're doing?
- -Andy
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org
iEYEARECAAYFAkmYDfkACgkQOjLpvpq7dMoqAACfT1TxLChnqSg/Exm8MZgN/z8m
2O0An3bnnQ309nTMiQI1JiEBTAUVQJeM
=vyL6
-----END PGP SIGNATURE-----
_______________________________________________
android-freerunner mailing list
[email protected]
http://android.koolu.org/listinfo.cgi/android-freerunner-koolu.org
_______________________________________________
android-freerunner mailing list
[email protected]
http://android.koolu.org/listinfo.cgi/android-freerunner-koolu.org
