Yes I agree that it should have clearly been put in the wiki. But I remember that the day Rowboat introduced 2.6.37 kernel branch, a mail was put on Rowboat mailing list notifying all these necessary changes.
Regards, Amit Pundir On 7/15/11, Manish Shakya <[email protected]> wrote: > Thanks got it. > > I think, this changes should be wrote in rowboat wiki. I wasted 2/3 days. > > > On Fri, Jul 15, 2011 at 2:04 PM, hedwin <[email protected]> wrote: > >> its in omap-serial.h in arch/arm/plat-omap/include/plat >> >> >> On Fri, Jul 15, 2011 at 7:58 PM, Manish Shakya >> <[email protected]>wrote: >> >>> Thanks.Yes, you were right. I tried replacing with O with S. Now I can >>> see logs in the console. >>> >>> Can you tell me where in the source code it says use ttyO instead of >>> ttyS? >>> I couldn't find in the source. >>> >>> Manish >>> On Fri, Jul 15, 2011 at 11:53 AM, Manish Shakya < >>> [email protected]> wrote: >>> >>>> >>>> What do you mean? >>>> >>>> so now uboot args should look something like this >>>> console=ttyS2,115200n8 androidboot.console=ttyO2 root=/dev/mmcblk0p2 rw >>>> rootfstype=ext3 rootwait init=/init vram=12M >>>> omapfb.mode=dvi:480x272MR-16@ >>>> 60 omapdss.def_disp=lcd43 >>>> >>>> Is this change in gingerbread 2.3.4 only? >>>> >>>> Manish >>>> >>>> >>>> On Fri, Jul 15, 2011 at 11:48 AM, hedwin <[email protected]>wrote: >>>> >>>>> in gingerbread ttyS changed to ttyO >>>>> >>>>> Hedwin >>>>> >>>>> >>>>> On Fri, Jul 15, 2011 at 5:44 PM, Manish Shakya < >>>>> [email protected]> wrote: >>>>> >>>>>> Right now I am trying to move from linux kernel 2.6.32 to 2.6.37 and >>>>>> use gingerbread 2.3.4. >>>>>> >>>>>> With linux kernel 2.6.32, froyo and gb 2.3.3 are working fine. I used >>>>>> same uboot arg as in earlier mail. >>>>>> >>>>>> On Fri, Jul 15, 2011 at 11:22 AM, hedwin >>>>>> <[email protected]>wrote: >>>>>> >>>>>>> Do you use froyo or gingerbread? >>>>>>> >>>>>>> >>>>>>> >>>>>>> On Fri, Jul 15, 2011 at 3:57 PM, manish shakya >>>>>>> <[email protected]>wrote: >>>>>>> >>>>>>>> Yes, Both console and android.console is pointing to correct serial >>>>>>>> device i.e. ttyS2. >>>>>>>> >>>>>>>> My uboot args is >>>>>>>> >>>>>>>> console=ttyS2,115200n8 androidboot.console=ttyS2 root=/dev/mmcblk0p2 >>>>>>>> rw rootfstype=ext3 rootwait init=/init vram=12M >>>>>>>> omapfb.mode=dvi:480x272MR-16@60 omapdss.def_disp=lcd43 >>>>>>>> >>>>>>>> Isn't this correct? >>>>>>>> >>>>>>>> >>>>>>>> On Fri, Jul 15, 2011 at 5:44 AM, hedwin <[email protected]> >>>>>>>> wrote: >>>>>>>> > >>>>>>>> > Check if console and android.console point to the correct serial >>>>>>>> device. >>>>>>>> > Both a kernel parameters sent by u-boot. >>>>>>>> > >>>>>>>> > Cheers, >>>>>>>> > >>>>>>>> > Hedwin >>>>>>>> > >>>>>>>> > On Thu, Jul 14, 2011 at 9:45 PM, Manish Shakya < >>>>>>>> [email protected]> wrote: >>>>>>>> >> >>>>>>>> >> Hi , >>>>>>>> >> >>>>>>>> >> I am wondering what are the changes to be made if I have to make >>>>>>>> to port rowboat to gumstix overo module. >>>>>>>> >> >>>>>>>> >> I did following things but it didn't worked. :-( >>>>>>>> >> I made change in config file , board-overo.c and also added LCD >>>>>>>> driver. Compilation went fine with out errors. >>>>>>>> >> But when I tried to run the image. It show following log and gets >>>>>>>> stuck. >>>>>>>> >> >>>>>>>> >> 2731240 bytes read >>>>>>>> >> ## Booting kernel from Legacy Image at 82000000 ... >>>>>>>> >> Image Name: Linux-2.6.37-g06ebbba >>>>>>>> >> Image Type: ARM Linux Kernel Image (uncompressed) >>>>>>>> >> Data Size: 2731176 Bytes = 2.6 MiB >>>>>>>> >> Load Address: 80008000 >>>>>>>> >> Entry Point: 80008000 >>>>>>>> >> Verifying Checksum ... OK >>>>>>>> >> Loading Kernel Image ... OK >>>>>>>> >> OK >>>>>>>> >> >>>>>>>> >> Starting kernel ... >>>>>>>> >> >>>>>>>> >> Uncompressing Linux... done, booting the kernel. >>>>>>>> >> >>>>>>>> >> >>>>>>>> >> -- >>>>>>>> >> Manish Shakya >>>>>>>> >> http://www.manishshakya.com.np >>>>>>>> >> >>>>>>>> >> -- >>>>>>>> >> unsubscribe: [email protected] >>>>>>>> >> website: http://groups.google.com/group/android-porting >>>>>>>> > >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> -- >>>>>>>> >>>>>>>> Manish Shakya >>>>>>>> http://www.manishshakya.com.np >>>>>>>> http://secs.oakland.edu/~ganesan/iMX/ >>>>>>>> >>>>>>> >>>>>>> >>>>>> >>>>>> >>>>>> -- >>>>>> Manish Shakya >>>>>> http://www.manishshakya.com.np >>>>>> http://secs.oakland.edu/~ganesan/iMX/ >>>>>> >>>>> >>>>> >>>> >>>> >>>> -- >>>> Manish Shakya >>>> http://www.manishshakya.com.np >>>> http://secs.oakland.edu/~ganesan/iMX/ >>>> >>> >>> >>> >>> -- >>> Manish Shakya >>> http://www.manishshakya.com.np >>> http://secs.oakland.edu/~ganesan/iMX/ >>> >> >> > > > -- > Manish Shakya > http://www.manishshakya.com.np > http://secs.oakland.edu/~ganesan/iMX/ > > -- > unsubscribe: [email protected] > website: http://groups.google.com/group/android-porting > -- unsubscribe: [email protected] website: http://groups.google.com/group/android-porting
