I'm at home now and don't have the Z with me... The needs reset and firmware came from a README file that was installed with the prism3-firmware ipk from the Angstrom feed. Evidently it's not needed? I really don't know what the differences are among Prism 2/2.2/3.
I'll have a fresh start in the morning and maybe make some progress then. Walt On Jun 27, 2007, at 5:09 PM, David L. Johnson wrote: > Walt S wrote: > >> I put things back as they were. Here is the except from the /etc/ >> network/interfaces file: >> >> iface wlan0 inet dhcp >> wireless_mode managed >> wireless_essid Travel >> wireless_key open key (10 hex digits) [1] key [1] >> needs_reset yes >> needs_firmware hostap_fw_load > > My settings, for no WEP, are similar, except that I allow any essid > and > wireless_key is off (and I have nothing about needing reset or > firmware). >> >> The documentation I have for WPA is conflicting. > > yeah, I know. I have to figure this out, eventually, when I either > get > a card that can handle it, or re-flash the one I have, and hopefully > someone can point the way to success. > > -- > > David L. Johnson > > I believe that the motion picture is destined to revolutionize our > educational system and that in a few years it will supplant largely, > if not entirely, the use of textbooks > -- Thomas Edison, 1922 > > _______________________________________________ > Angstrom-distro-users mailing list > [email protected] > http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro- > users _______________________________________________ Angstrom-distro-users mailing list [email protected] http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-users
