Jack,
All your machines are "Fast" so the "Profile FASTPC.ACF" should work with all
of them. However, Michael Dawley had some of the same troubles with a Compaq
(950?) and had to revert to a dialer other than Miniterm. (Michael D., jump
in and let Jack know what you had to do with the Compaq.)
I see that you have the terminal "on". What do you see as it attempts to log
on?
Is the "WaitFor1 login:" really "login:" or is it "Login:"?
Try changing "IP_Address PPP" to "IP_Address %MYIP%". (Is your IP static or
dynamic?)
These are the only suggestions that I have for now.
Roger Turk
Tucson, Arizona USA
Jack Cotter wrote:
>>A.The machines that do not work:
1.Compaq Deskpro 590 (Intel Pentium 90) using a USRobotics 56K V90
external modem on Com1. 750 M IDE drive one partition with DOS 6.22. The
Arachne.cfg file for this machine is shown below.
2. Home built Intel Pentium 100 on a genaric mobo. Same modem as above
and some others. 1 G hard drive triple boot: Win31, Win95 (retail), and
Linux.
B.The machines that work :
1. Home built Intel Pentium 100 on a genaric mobo. NewCom 56K (56ifxvC
upgraded forV90) on Com2. 4G HDD (FAT32) with a dual boot: Win95 OSR2.5
(0.6G), and Linux (3.4G).
2. Home built Cyrix MII 200 on a M571 TX -Pro II mobo. Modem as in A.1.
above. 8.2G HDD one partition (FAT32) using Win95 OSR2.5. This is my
primary working machine and has a wide range of software on it.
I configured each machine individually for Arachne. I tried the modem
from A1. above in A.2. A2 is down with a sick power supply at the
moment.
A question on protocol. When asked for the config. file do you really
want it all or should I take out the "boiler plate"?
Thankyou for answering.
Jack Cotter<<
