Since some people seem to be having problems using LSPPP, I have included my arachne.cfg file below. You will note ALL the lsppp instructions are on the "Dialer line" and I have commented out all my previous stuff that was needed for for a Minicom-Epppd connection. I followed Glenn's "Connection" suggestion, but did not go down the "set environment" route mostly because I'm too dumb to understand it (I'm really a neophyte in all this). When you click on "dial" on the ppp_init.htm page, you get small blue type overwriting the page in the upper left-hand corner to let you know what lsppp is doing. This disappears after your home page comes up and thereafter things work as normally as I can determine. Klaus Hameyer Burlington, VT (USA) Portion of ARACHNE.CFG: ; Modified by K. Hameyer for LSPPP on 2/16/01 ; [profile] Profile LSPPP-BUR.ACF Connection @lspppd.exe>>PPP.LOG Hangup @termin.com 0x60>NUL [dialer] DialPage file:ppp_init.htm Dialer @lh lsppp /d:6604362 /n:2 /B:57600 /N:209.198.87.40 /U:Pkhameyer /P:****** ;TerminalWindow @MINITERM.EXE ;UseTerminal No ;Port 2 ;Irq 3 ;Base 0x2f8 ;Mode 8N1 ;Speed 115200 ;InitString AT&F ;DialString ATDT ;PhoneNumber 660-4362 ;Autologin Yes ;WaitFor1 oglin: ;Response1 \u ;WaitFor2 assword: ;Response2 \p ;WaitFor3 ;Response3 ;PPPusername Pkhameyer ;PPPpassword ****** ;Port values: 0=non-standard serial (COM) port, 1-4 standard ports ;Base values: 0x??? (eg. 0x3e8) - Base and Irq are used for "Port 0" ;Mode values: databits/parity/stopbits (eg. 8N1) [tcp/ip] IP_Address PPP IP_Grab IP address set to NameServer 209.198.87.40 AltNameServer 209.198.87.41 Gateway 0.0.0.0 AltGateway 0.0.0.0 Netmask 0.0.0.0 TCPconfig PPPTCP.CFG
