On Wed, 21 Feb 2001 06:54:23 -0500 (EST), Klaus Hameyer wrote: > You will note ALL the lsppp instructions are on the "Dialer line" > and I have commented out all my previous stuff that was needed for > for a Minicom-Epppd connection. I followed Glenn's "Connection" > suggestion, but did not go down the "set environment" route > mostly because I'm too dumb to understand it (I'm really a neophyte > in all this). > [dialer] > DialPage file:ppp_init.htm > Dialer @lh lsppp /d:6604362 /n:2 /B:57600 /N:209.198.87.40 /U:Pkhameyer > /P:****** An alternative to specifying the information here is to write a simple batch file called setlsppp.bat as per Glenn's suggestion. (Glenn loves batch files) Or you could just give the information switches on the command line before starting Arachne. Of course that's after you figure out which of the switches you need for your particular situation. I do like this method of yours of putting the information all on the Dailer line in Arachne.cfg That seems easier than Glenn's method. Simpler to use if all you want to use is Arachne. Sam Ewalt Croswell, Michigan, USA -user of The Arachne Browser - http://arachne.cz/ -- Arachne V1.70;rev.3, NON-COMMERCIAL copy, http://arachne.cz/
