marvin horst wrote:
I know it's wired properly because you can set mode LPb to 3 (metallic
bypass) which bypasses any processing on the echo card. After doing
this T100P was communicating with channel bank as before.
Bad card?
On the red Rcv In, have you tried swapping out the cable for the
opposite cable type. If xfer, change to straight though? Also, have
you tested both of the cables to verify they are good?
I've confirmed my card settings are the same as yours:
Framing: ESF
Line Coding: B8ZS
Busy/Idle detection: CAS
My ADIT:
> show a:1
SLOT A:
Settings for DS1 1:
Circuit ID: CAC DS1# A:1
Up/Down: UP
Framing: ESF
Line Coding: B8ZS
Line Build Out: DSX-1 EQUALIZATION FOR 0-133 ft. (CSU 0dB)
Loop Code Detection: CSU
Loopback: OFF
FDL Type: None
--
Ben Franklin quote:
"Those who would give up Essential Liberty to purchase a little Temporary Safety,
deserve neither Liberty nor Safety."
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
