Hi Philip, I found the problem. My sip.conf config was changed by somebody else. :( The external IP was uncommented and that's what is causing my problem.
----- Original Message ----- From: "Jess Magnaye" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Tuesday, December 23, 2003 4:33 PM Subject: Re: [Asterisk-Users] Fw: Questions and finding > > > > Hi! > > > > > 1. My VAD is turned off (00140014), and it didn't help for that cut-off. > > > > Then check if you have a firewall in between * and your ATA that closes > > the port due to inactivity of your ATA. Also use "SIP DEBUG" in the CLI > > to try to see a bit more of what is going on. You could also use Ethereal > > to monitor the SIP traffic (or the rtp/UDP traffic). > > > > > am not sure if OutboundProxy has to be configured to have it working > fine. > > > Or this just happened to me? What is your ATA's software? > > > > I don't have such a device, in fact never had. :-) > > MY ATA and * are sitting on the same LAN. So FW or NAT problem is not > possible. This is also the reason why I commented out "nat=1" in the > sip.conf. > > > > 2. I tried dtmfmode=inband on sip.conf, and dtmfmode=rfc2833. None > worked. > > > > Note: inband only works with g.711 codec. Doesn't the ATA also offer > > "info" as third dtmfmode option? Anyway, you might want to search the > > mailing list for setup info, there are a lot of people around that use > > it. > > > > > by setting Audiomode, but nothing helped. I was thinking the * is > > > ONLY recognizing the DTMF if there is telco board installed. Is it? > > > > No no, * doesn't require any hardware to be installed. > > > LET ME TRY dtmfmode=info AND SEE WHAT HAPPENS NEXT. > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
