What is in your config file ? zaptel.conf ? also, check the crc4 settings and maybe the wire you are using is wrong since some equippment needs crossed wires, some needs straight wires. Crossed would be 1-4 2-5
cheers Michael On Thu, 2004-06-17 at 10:28, Wolfgang Pichler wrote: > Am Do, den 17.06.2004 schrieb Peter Svensson um 9:43: > > On Thu, 17 Jun 2004, Wolfgang Pichler wrote: > > > > > ... on the card i can see the two leds pulsing red (i think thats the > > > yellow alaram - or i am wrong) ? > > > > Are you sure it is not a red alarm? That would indicate a loss of link. > > I think you can check with the command zttool. > you are right - its a red alarm - zttool says "Red Alarm/Not Open" > > > > Are you sure the cables are correct? > > Have you set the jumpers on the card to E1 and not left them on T1? > The jumpers are on E1 - the cables should be ok (they are working with > other hardware) - and the card is directly connected to a simens ULAF+ > STU Desktop (can't really find much information about this device on the > net) - which turns off a red led when i load the driver and do a ztcfg. > > > > I think the leds should turn green when the card senses a correct carrier > > and framing on the lines. > green is always a wounderful color ;-) > > so, what else could cause this ? > > wolfgang > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
