Am Do, den 17.06.2004 schrieb Peter Svensson um 10:38: > On Thu, 17 Jun 2004, Wolfgang Pichler wrote: > > > > Are you sure the cables are correct? > > > Have you set the jumpers on the card to E1 and not left them on T1? > > The jumpers are on E1 - the cables should be ok (they are working with > > other hardware) - and the card is directly connected to a simens ULAF+ > > STU Desktop (can't really find much information about this device on the > > net) - which turns off a red led when i load the driver and do a ztcfg. > > Then the tx (from TE410P to the Siemens equipment) circuit is ok but the > rx may not be. but the same cable works great with an other hardware (a Parlay i60) > > > > I think the leds should turn green when the card senses a correct carrier > > > and framing on the lines. > > green is always a wounderful color ;-) > > > > so, what else could cause this ? > > I'd try to find out if the cable is wired the way the TE410P expects it to > be. Do you know the pinout of both ends of the cables? RX (from the TE410P > point of view) should be on the pins 1-2 at the TE410P end and TX on 4-5. would be a great thing if you can find something more than i found
best regards wolfgang _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
