Take a look at
http://www.freepbx.org/trac/ticket/1447
and
http://aussievoip.com/wiki/freePBX-CustomContexts
this is an unofficial module and so may have unexpected consequences
I personally prefer to use extensions_custom.conf, but....
YMMV
Martin
David Cook wrote:
I haven't come across the "custom contexts module". Where is this one
accessed? I thought I had all the modules in the system now and I don't see
that listed.
- dbc.
I've never tried multiple accounts on a single Aastra phone, but I would
assume that if you have selected "line 3/account 3" for example, it
would go out using that account information. I know one can do this
using Snom's.
As far as Trixbox is concerned, I think you would have to put this
account into a different context and handle that context route
differently. You can either do this in extensions_custom.conf or install
the custom contexts module under FreePBX (if you wanted to stay in the GUI).
Martin
Drew Gibson wrote:
I tried to do something similar a while back but got nowhere. I set up a
separate registration for each of the "personalities" or "lines" but
Asterisk could not differentiate between the two registrations on the
same IP address for outbound calls.
regards,
Drew
David Cook wrote:
I have a need to use a special route for one source-line only and I can't
figure out how to make trixbox do it from within the GUI. (I'd prefer to
stay within the GUI in this particular case).
Here is the scenario:
Phone 202 has registrations for SIP/202 on L1/L2, and SIP/302 on L3.
I want a different route if the user picks L3 (source SIP/302) than if
they
pick L1/L2 to dial. I want the dial pattern to be the same, eg: dial
9+[1]+10. I do not want a separate predecessor digit to identify which
route
to use.
Any ideas? Am I missing something very obvious.
- dbc.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
