Dave, http://freepbx.org/support/documentation/module-documentation/third-part y-unsupported-modules/customcontexts
Elliott -----Original Message----- From: David Cook [mailto:[EMAIL PROTECTED] Sent: Tuesday, April 01, 2008 9:17 PM To: 'Martin Glazer'; 'TAUG' Subject: RE: [on-asterisk] Trixbox outbound route question I haven't come across the "custom contexts module". Where is this one accessed? I thought I had all the modules in the system now and I don't see that listed. - dbc. I've never tried multiple accounts on a single Aastra phone, but I would assume that if you have selected "line 3/account 3" for example, it would go out using that account information. I know one can do this using Snom's. As far as Trixbox is concerned, I think you would have to put this account into a different context and handle that context route differently. You can either do this in extensions_custom.conf or install the custom contexts module under FreePBX (if you wanted to stay in the GUI). Martin Drew Gibson wrote: > I tried to do something similar a while back but got nowhere. I set up > a separate registration for each of the "personalities" or "lines" but > Asterisk could not differentiate between the two registrations on the > same IP address for outbound calls. > > regards, > > Drew > > > David Cook wrote: >> I have a need to use a special route for one source-line only and I >> can't figure out how to make trixbox do it from within the GUI. (I'd >> prefer to stay within the GUI in this particular case). >> >> Here is the scenario: >> >> Phone 202 has registrations for SIP/202 on L1/L2, and SIP/302 on L3. >> >> I want a different route if the user picks L3 (source SIP/302) than >> if they pick L1/L2 to dial. I want the dial pattern to be the same, >> eg: dial >> 9+[1]+10. I do not want a separate predecessor digit to identify >> 9+which >> route >> to use. >> >> Any ideas? Am I missing something very obvious. >> >> - dbc. >> >> >> >> >> > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] For additional > commands, e-mail: [EMAIL PROTECTED] > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
