Just got an x100p
card today to play with. Only thing is I am having some troubles getting
it to work. Probably just me being stupid and not knowing much about
Linux.
Anyway. I
installed card in machine and did a fresh install (disk drive had been flattened
using fdisk first). Edited the zapata.conf setting the channel and the
such, made a simple dial plan in extensions, added load => chan_zap.so to the
modules.conf file (not sure if this is needed) and tried to change the
zaptel.conf file. Rebooted and nothing seemed to work. I did notice
the zaptel.conf file was again empty so I tried remounting as rw, edited file
and rebooted but still didn't work.
After a quick browse
I found a few posts saying you need to do some modprobes first and then
ztcfg. Is this correct?
When I tried this
the modprobe wcfxo reported a wildfire x100 but ztcfg could not find the
zaptel.conf file.
Does anybody have a
dumb users guide to installing this or am I going in the right
direction.
Any help would be
appreciated.
Graham.
smime.p7s
Description: S/MIME cryptographic signature
_______________________________________________ Astlinux-users mailing list [email protected] http://lists.kriscompanies.com/mailman/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to [EMAIL PROTECTED]
