Guntha wrote:
> Just got an x100p card today to play with. Only thing is I am having
> some troubles getting it to work. Probably just me being stupid and not
> knowing much about Linux.
>
> Anyway. I installed card in machine and did a fresh install (disk drive
> had been flattened using fdisk first). Edited the zapata.conf setting
> the channel and the such, made a simple dial plan in extensions, added
> load => chan_zap.so to the modules.conf file (not sure if this is
> needed) and tried to change the zaptel.conf file. Rebooted and nothing
> seemed to work. I did notice the zaptel.conf file was again empty so I
> tried remounting as rw, edited file and rebooted but still didn't work.
>
> After a quick browse I found a few posts saying you need to do some
> modprobes first and then ztcfg. Is this correct?
> When I tried this the modprobe wcfxo reported a wildfire x100 but ztcfg
> could not find the zaptel.conf file.
>
> Does anybody have a dumb users guide to installing this or am I going in
> the right direction.
>
> Any help would be appreciated.
>
> Graham.
>
Graham,
Are you in the UK? I am not sure that you will have good success with
the X100P - it only supports 600ohms which is used in the US. I don't
know what they use in the UK but I know that it isn't 600 ohms...
You need to create a keydisk - use genkd to do this.
--
Kristian Kielhofner
_______________________________________________
Astlinux-users mailing list
[email protected]
http://lists.kriscompanies.com/mailman/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to [EMAIL
PROTECTED]
