On 15:58 Fri 08 Feb , Alexander Shiyan wrote: > Hello. > > ... > > > +menu "CLPS711X specific settings" > > > + > > > +config CLPS711X_CPU_PLL_MULT > > > + int "CPU PLL multiplier (20-50)" > > > + range 20 50 > > > + default "40" > > > + help > > > + Define CPU PLL multiplier. PLL is calculated by formula: > > > + PLL Frequency = (PLL Multiplier / 2) * 3686400 Hz > > > + Default value is 40, for achieve 73 MHz. > > > + > > this board specific put this in c code > > kconfig is too easy to break > > > > check how we do on at91 > > This is not board-specific, this is CPU-specific. PLL multiplier is set up > at the start and we not touch it anymore since all system frequencies is > depends on it, including SDRAM refresh. > How to place this configurable parameter in C code i am not understand. > For Kconfig, we can add additional compile-time checker into lowlevel unit > which uses this symbol: > > #if (CLPS711X_CPU_PLL_MULT < 20) || (CLPS711X_CPU_PLL_MULT > 50) > #error "CPU PLL multiplier out of range" > #endif so it's even worse
detect the cpu in c and dorp the Kconfig Best Regards, J. > > Thanks! > > --- _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox
