Create the PHY node with properly configured phy-mode and reset lines. In this case we will not need board specific PHY fixups.
Signed-off-by: Oleksij Rempel <[email protected]> --- arch/arm/dts/imx6q-vicut1.dts | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-) diff --git a/arch/arm/dts/imx6q-vicut1.dts b/arch/arm/dts/imx6q-vicut1.dts index 9f60ed1ac2..9747b3c62e 100644 --- a/arch/arm/dts/imx6q-vicut1.dts +++ b/arch/arm/dts/imx6q-vicut1.dts @@ -19,9 +19,23 @@ &fec { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_enet>; - phy-mode = "rgmii"; - /* phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>; */ + phy-mode = "rgmii-id"; + phy-handle = <&rgmii_phy>; status = "okay"; + + mdio { + #address-cells = <1>; + #size-cells = <0>; + + /* Microchip KSZ9031RNX PHY */ + rgmii_phy: ethernet-phy@4 { + reg = <4>; + interrupts-extended = <&gpio1 28 IRQ_TYPE_LEVEL_LOW>; + reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>; + reset-assert-us = <10000>; + reset-deassert-us = <300>; + }; + }; }; &iomuxc { -- 2.28.0 _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox
