Thanks for the suggestion; I tried several times in a row, it didn't change
anything.
I went ahead and copied a bunch of commands, the dmesg output afterwards,
and the results of ifconfig and iwconfig... Did I miss something (also plz
tell me if I just published all someone needs to hack into my comp!):
#: ifconfig eth1 down
#: ifconfig eth1 up
#: iwconfig eth1 essid "frank"
#: iwconfig eth1 key open
#: iwconfig eth1 key 74b571f1c9
bcm43xx: Radio turned off
bcm43xx: DMA-32 0x0200 (RX) max used slots: 1/64
bcm43xx: DMA-32 0x02A0 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0280 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0260 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0240 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0220 (TX) max used slots: 2/512
bcm43xx: DMA-32 0x0200 (TX) max used slots: 0/512
bcm43xx: Microcode rev 0x127, pl 0xe (2005-04-18 02:36:27)
bcm43xx: Radio turned on
bcm43xx: Radio enabled by hardware
bcm43xx: Chip initialized
bcm43xx: 32-bit DMA initialized
bcm43xx: Keys cleared
bcm43xx: Selected 802.11 core (phytype 2)
SoftMAC: Canceling existing associate request!
SoftMAC: Associate: Scanning for networks first.
SoftMAC: Scanning finished: scanned 13 channels starting with channel 1
SoftMAC: Queueing Authentication Request to 00:0e:a6:71:de:05
SoftMAC: Cannot associate without being authenticated, requested
authentication
SoftMAC: Sent Authentication Request to 00:0e:a6:71:de:05.
SoftMAC: Open Authentication completed with 00:0e:a6:71:de:05
SoftMAC: sent association request!
SoftMAC: associated!
eth1: no IPv6 routers present
bcm43xx: set security called, .level = 1, .enabled = 1, .encrypt = 1,
.auth_mode = 0
bcm43xx: set security called, .active_key = 0, .level = 1, .enabled = 1,
.encrypt = 1
64studio:/home/chuckk# ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:14:A5:D0:1C:7A
inet6 addr: fe80::214:a5ff:fed0:1c7a/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:33 errors:0 dropped:3762 overruns:0 frame:0
TX packets:114 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3916 (3.8 KiB) TX bytes:7512 (7.3 KiB)
Interrupt:11
64studio:/home/chuckk# iwconfig eth1
eth1 IEEE 802.11b/g ESSID:"frank" Nickname:"Broadcom 4311"
Mode:Managed Frequency=2.462 GHz Access Point:
00:0E:A6:71:DE:05
Bit Rate=24 Mb/s Tx-Power=18 dBm
RTS thr:off Fragment thr:off
Encryption key:74B5-71F1-C9 Security mode:open
Link Quality=85/100 Signal level=-49 dBm Noise level=-69 dBm
Rx invalid nwid:0 Rx invalid crypt:3764 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
_______________________________________________
Bcm43xx-dev mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
